​[FW] MB10 Global Update Firmware update. Xiaomi Band 10 => CN to Global. IMPORTANT!! The update installs the official global firmware, version 2.1.77 for now. After installation, the device becomes global and will continue to update officially. Update procedure: 1. Install MiFitness mod v1.39u+ from the bot @mi_watch_bot. Send the command /latestapp to the bot, it will give you a download link for the app. 2. Go to Watchfaces → Store. Then go to Firmwares and select the watchface \[FW] MB10 Global Update. 3. Press the button at the bottom — it will redirect you to the bot. Follow the bot’s instructions to get payment details or a payment link. 4. Make the payment via PayPal. 5. Wait for the activation message from the bot. If you face any issues, contact support: @stas_miwatch_support. 6. Go back to MiFitness into watchface. 7. Install the firmware. The update takes place in two stages: I. Install the watchface. After successful installation, the watch will display "Installation complete". Do not reboot the watch, proceed to the next step. II. Go to MiFitness → Device → More → Update and download the update. The update process takes about 15 minutes, depending on your phone. 8. On the watch, go to System → Reset and perform a reset. 9. In MiFitness, do not do anything except following: change the region to any global region) and reconnect the watch. That’s it — now you have a global watch in a global region, which will update normally through either the modded or the official app. PS: The current update is based on firmware 1.2.162. If your watch is on a different version, the update is also available in the Firmwares section.